ProjectSums

Methodology

How the calculators are built, what they assume, and where a number comes from.

How formulas are chosen

A calculator uses the simplest formula that matches how the material is actually sold. Area and volume come from standard geometry. The unit conversion — cubic feet to cubic yards, square feet to roofing squares, inches to feet — is exact, not a rounded rule of thumb. Where a product has its own yield, that yield comes from the manufacturer’s data sheet rather than a single number applied to every brand.

The references we start from are manufacturer data sheets (including QUIKRETE, GAF, Sherwin-Williams, and Custom Building Products), the International Residential Code, ENERGY STAR and U.S. Department of Energy insulation guidance, and ordinary geometry. A code citation is a check on limits such as stair rise, not a permit.

Rounding and waste

Material counts always round up to a whole bag, box, sheet, bundle, roll, or board. The exact figure is shown beside the rounded one so you can see whether you are barely over a whole unit. Waste is a separate percent, with a default and a range, because cuts, spillage, and pattern match are not part of the bare geometry. The page shows the area or volume before waste so the allowance is visible. Waste is not added twice if you carry a square-footage total into another calculator.

How a tool is checked

Each calculator is tested against two references before the numbers are treated as settled: the manufacturer’s published yield or coverage, and a hand-worked geometry check (or the relevant code table, for stairs). If those two disagree, the page says which figure it used and why. A worked example on the calculator page uses the same inputs as the form, so the prose and the result panel match.

Sources

Corrections

If a formula, a default, or a worked example is wrong, write to us from the contact page. Say which calculator, what you entered, and what you expected. We would rather correct a page than defend a bad yield.